Brian from Edison, NJ has been a Green Sun Energy Services client since May of 2024. The generator was commissioned that August: 14 kW on natural gas, on a 100-amp service-entrance switch with surge protection, sized against a 14 kW calculation for the 1,451 square foot house. One condition was set out before the work: six feet of the garage had to be cleared back from the door openings to give the electrical crew room to work. It sounds trivial and it is not – the transfer switch and the conduit runs need real working space, and an installation day that begins with moving somebody’s belongings is a day that finishes late. A sump pump, a refrigerator, a washer and a gas dryer make up the load, and the generator is supported by annual maintenance, a ten-year extended parts-and-labor warranty and monitoring we manage.
Project Facts
- Location
- Edison, NJ
- Services
- Standby Generator Installation, Standby Generator Service
- Client since
- May 2024
- Manufacturer
- Generac Model # 7223
- Rated output
- 14 kW LP / 14 kW NG
- Fuel
- Natural Gas
- Home sized for
- 1,451 sq ft
- Electrical service
- 100 amp
- Transfer switch
- 100 amp
- Load management
- Managed Whole House
Standby generator questions from Edison homeowners
Will a 14 kW generator run an entire Edison house?
For many homes, yes, but that does not mean every load can run at the same moment. Houses with two central air conditioners, electric heat, EV charging, pool equipment or electric cooking may need load management or a larger machine. The answer comes from a load calculation rather than from the phrase whole house.
What does remote monitoring actually tell you?
Depending on the generator and the connectivity, remote monitoring can report status, maintenance notifications, alarms, exercise information and operating history. Its real value is that a fault announces itself between service visits, instead of being discovered during the outage it was bought for.
Can the generator be connected to any nearby gas pipe?
No. The branch supplying the generator has to be sized for the flow and pressure the machine needs. A pipe that happens to be close by may be too small, or may already be carrying too much load. Undersized piping shows up as poor starting, unstable running, reduced output or a generator that shuts down under load.