19.5 kW Standby Generator Installation in Red Bank, NJ | Whole-House Standby, An Electric Kitchen Sets the Requirement

Red Bank, NJ · Client since August 2024

Enrique from Red Bank, NJ has been a Green Sun Energy Services client since August of 2024. A Generac model 7042-2 was commissioned three weeks after it was booked, rated 19.5 kW on natural gas against a load calculation asking for 19 kW. The house is 2,600 square feet, but the kitchen and laundry are electric – a range, a second oven and an electric dryer – which is what puts the requirement so close to the machine’s rating. Two load-management modules and a surge protective device went in with it, on a 200-amp service carrying the whole house.

Project Facts

Location
Red Bank, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
August 2024
Manufacturer
Generac Model # 7042-2
Rated output
22 kW LP / 19.5 kW NG
Fuel
Natural Gas
Home sized for
2,600 sq ft
Electrical service
200 amp
Transfer switch
200 amp
Load management
Managed Whole House

Standby generator questions from Red Bank homeowners

Can a generator be installed in a flood zone in Red Bank?

Yes, but the generator and its electrical equipment may need to be elevated or otherwise protected. The installation is evaluated against the property's FEMA flood zone, its Base Flood Elevation and Design Flood Elevation, the municipal flood ordinance, any applicable freeboard, and NJDEP requirements where they apply. It is a property-by-property assessment rather than a rule of thumb.

Is an emergency shutdown required?

The 2023 National Electrical Code contains requirements addressing emergency shutdown of generator prime movers. Whether and how they apply is determined from the generator's rating, its location, the model and the installation, and the factory equipment is evaluated against them rather than presumed to comply.

How does the starting battery stay charged?

The system includes battery-charging provisions so the starting battery stays ready while the generator waits for an outage. A charging fault, a blown fuse, a wiring problem or simply a tired battery can stop a generator starting when it is needed, which is why battery condition is part of routine maintenance rather than an afterthought.

Scroll to Top