Generac 20 kW Standby Generator in Farmingdale, NJ | 2,600 Sq. Ft., Running in Nine Weeks

Standby Generator Installation and Standby Generator Service in Farmingdale, NJ
Standby Generator Installation and Standby Generator Service in Farmingdale, NJ by Green Sun Energy Services.

Farmingdale, NJ · Client since September 2013

Frank from Farmingdale, NJ has been a Green Sun Energy Services client since September of 2013. He signed in early September and the generator was commissioned in the middle of November, a 20 kW Generac on its own pad behind a 200-amp service-rated transfer switch with two power management modules. It covers 2,600 square feet with a refrigerator, a freezer, a dishwasher, an electric oven and the laundry. Nine weeks from signature to running. Farmingdale is in Monmouth County.

Project Facts

Location
Farmingdale, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
September 2013
Manufacturer
Generac Model # 6244
Rated output
20 kW LP / 18 kW NG
Fuel
Natural Gas
Home sized for
2,600 sq ft
Electrical service
200 amp
Transfer switch
200 amp
Load management
Managed Whole House

Standby generator questions from Farmingdale homeowners

What size standby generator does a Farmingdale home need?

The correct size is decided by the electrical loads the generator is expected to run, not by the square footage of the house. Central air, heat pumps, electric heat, well and sump pumps, refrigerators and freezers, electric ranges and dryers, pool equipment and EV chargers all count. Where a load is connected automatically, the generator either has the capacity for it or an approved load-management system controls it.

How deep does the electrical conduit have to be buried?

It depends on the wiring method and the location; there is no single burial depth for every installation. The National Electrical Code governs underground wiring and sets minimum cover in a table, and the conduit type, the location and the physical protection all change the answer.

Should gas pressure be checked while the generator is running?

Yes. Operating pressure means more than a static reading taken with the generator off. The fuel system has to hold adequate pressure while the generator runs and other appliances may also be drawing gas. That matters most when an existing residential service is being reused.

Scroll to Top