Generac 16 kW Standby Generator in Belford, NJ | Installed 2014, Serviced Ever Since

Standby Generator Installation and Standby Generator Service in Belford, NJ
Standby Generator Installation and Standby Generator Service in Belford, NJ by Green Sun Energy Services.

Belford, NJ · Client since July 2014

Vincent from Belford, NJ has been a Green Sun Energy Services client since July of 2014. He signed at the end of July and the generator was running by the middle of September, a 16 kW Generac on a pad behind a 200-amp service-rated transfer switch, supplied with a five year warranty. A Generac service contract has covered it in the years since, which is the only reason a 2014 unit is still a working machine rather than a lawn ornament. Belford is in Monmouth County.

Project Facts

Location
Belford, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
July 2014
Manufacturer
Generac Model # 6462
Rated output
16 kW LP / 16 kW NG
Fuel
Natural Gas
Home sized for
1,679 sq ft
Electrical service
200 amp
Transfer switch
200 amp
Load management
Managed Whole House

Great company. Really helped me when I needed them most. My generator failed due to a faulty oil pressure switch. They came out 1st thing the next day and got me up and running in no time. Thanks again Glen.

— Vincent2024Reviewed us onGoogle

Green Sun Energy Services replied

Thank you, Vincent. A failed oil pressure switch is exactly the sort of fault that only shows up when the machine is asked to run, and getting there the next morning is the least a standby generator customer should expect. The 16 kW Generac at your home in Belford has been ours to look after since 2014, and that history is why the diagnosis was quick.

Standby generator questions from Belford homeowners

Does a generator in Belford have to sit twelve inches above the flood elevation?

That figure should not be treated as a universal rule without looking at the actual property. The required elevation can depend on the flood-zone designation, the municipal freeboard, the Design Flood Elevation, Coastal A or V Zone conditions, NJDEP requirements and the applicable building-code provisions. Each flood-zone installation is worked out individually.

Can the exercise time be changed?

Yes, though the procedure depends on the controller and the model, and older and newer control platforms use different setup interfaces. Remote monitoring may also offer it, depending on the generator.

Can the existing natural-gas service in a Belford home supply a generator?

Often yes, but the gas system has to be evaluated first. The review covers the generator's BTU demand, meter capacity, available pressure, regulator capacity, pipe diameter and length, and every other gas appliance in the house -- furnace, boiler, water heater, range and fireplace among them.

Scroll to Top