Dino from Belford, NJ has been a Green Sun Energy Services client since August of 2021. The generator was commissioned that December: 14 kW on natural gas, on a 100-amp service-entrance switch with a smart management module. The calculation asked for 13 kW across the 1,812 square foot house, so the machine and the requirement are closely matched – and on a 100-amp service there is no spare headroom to absorb a bad estimate, which is why the survey matters more here than on a modern 200-amp panel. Belford sits on the bay behind Sandy Hook, in the part of Monmouth County that loses power to nor’easters as reliably as to summer storms. The generator is supported by annual maintenance, an extended parts-and-labor warranty, and monitoring we manage.
Project Facts
- Location
- Belford, NJ
- Services
- Standby Generator Installation, Standby Generator Service
- Client since
- August 2021
- Manufacturer
- Generac Model # 7223
- Rated output
- 14 kW LP / 14 kW NG
- Fuel
- Natural Gas
- Home sized for
- 1,812 sq ft
- Electrical service
- 100 amp
- Transfer switch
- 100 amp
- Load management
- Managed Whole House
Standby generator questions from Belford homeowners
Can Belford require a generator to sit farther from the house than the manufacturer does?
Yes. Another applicable requirement can result in greater separation than the manufacturer's listed minimum -- equipment may be permitted eighteen inches from a qualifying wall while the local ordinance requires several feet from a property line. Both requirements have to be satisfied; neither cancels the other.
Does the generator have to be bolted down?
Not every ground-level installation uses the same anchoring method. The requirement changes with the model, the pad type, wind exposure, flood requirements, elevated platforms and any local engineering requirement. The model manual and the site conditions decide it.
How can a whole house be carried on a smaller electrical service?
Through load management. One or more large loads are controlled so they do not start at the same moment, or shut down briefly if generator demand climbs too high. That is what allows whole-house coverage where the raw sum of every connected load would otherwise exceed the machine.