18 kW Standby Generator Installation in Farmingdale, NJ | Generac Generator

Farmingdale, NJ · Client since July 2024

Helen from Farmingdale, NJ has been a Green Sun Energy Services client since July of 2024. The generator was commissioned that October: 18 kW on natural gas, on a 150-amp service-entrance switch with a smart management module and surge protection. The load calculation asked for 13 kW across the 2,066 square foot house, and a double electric oven is the appliance doing most of the work in that figure – two elements drawing together approach the demand of everything else in the house combined. The machine sits comfortably above the requirement rather than at it. Annual maintenance, an extended parts-and-labor warranty and monitoring we manage all sit behind it.

Project Facts

Location
Farmingdale, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
July 2024
Manufacturer
Generac Model # 7226
Rated output
18 kW LP / 17 kW NG
Fuel
Natural Gas
Home sized for
2,066 sq ft
Electrical service
150 amp
Transfer switch
150 amp
Load management
Managed Whole House

Standby generator questions from Farmingdale homeowners

Does a propane generator need permits in Farmingdale?

A permanently installed propane generator normally requires construction permits, and the propane installation has to satisfy the applicable fuel-gas and LP-gas requirements. Tank placement, capacity, piping, regulators, setbacks and fire-safety provisions all come under review.

How can a whole house be carried on a smaller electrical service?

Through load management. One or more large loads are controlled so they do not start at the same moment, or shut down briefly if generator demand climbs too high. That is what allows whole-house coverage where the raw sum of every connected load would otherwise exceed the machine.

Does the generator need its own gas shutoff?

The fuel installation has to include the shutoff arrangements required by the adopted fuel-gas code and by the installation instructions. The valve must be positioned where it is accessible, both for servicing and for isolating the machine in an emergency.

Scroll to Top