22 kW Standby Generator Installation in Freehold, NJ | Generac Generator

Freehold, NJ · Client since October 2020

Jerry from Freehold, NJ has been a Green Sun Energy Services client since October of 2020. The generator was commissioned in August of 2021: a Generac Guardian rated 19.5 kW on natural gas, on a 200-amp service-entrance switch with six smart management modules. Six modules is the largest load management arrangement on the site, and the survey shows why – two washers, an electric dryer and a gas dryer, a double electric oven, three refrigerators, two dishwashers and a sump pump, across 4,500 square feet. A house with two of nearly everything can start several heavy loads at the same moment, and each module holds one of them back for long enough that the machine is never asked for all of it at once. The calculation came to 19 kW and the generator matches it.

Project Facts

Location
Freehold, NJ
Service
Standby Generator Installation
Client since
October 2020
Manufacturer
Generac Model # 7043-2
Rated output
22 kW LP / 19.5 kW NG
Fuel
Natural Gas
Home sized for
4,500 sq ft
Electrical service
200 amp
Transfer switch
200 amp
Load management
Managed Whole House

Standby generator questions from Freehold homeowners

Does a propane generator need permits in Freehold?

A permanently installed propane generator normally requires construction permits, and the propane installation has to satisfy the applicable fuel-gas and LP-gas requirements. Tank placement, capacity, piping, regulators, setbacks and fire-safety provisions all come under review.

Which fuel-gas code applies?

New Jersey currently adopts the 2024 International Fuel Gas Code as its Fuel Gas Subcode, which is what governs the piping, testing and shutoff arrangements on a natural-gas generator installation.

Can the generator be connected to any nearby gas pipe?

No. The branch supplying the generator has to be sized for the flow and pressure the machine needs. A pipe that happens to be close by may be too small, or may already be carrying too much load. Undersized piping shows up as poor starting, unstable running, reduced output or a generator that shuts down under load.

Scroll to Top