Justin from Belle Mead, NJ has been a Green Sun Energy Services client since December of 2021. The generator was installed by another company and commissioned in August of 2010, and the servicing came to us eleven years later. It has been seen every year since – December of 2021, January of 2023, January of 2024, December of 2024 and December of 2025 – starting at the eight-year service and settling into the ten-year interval, with one repair visit handled in June of 2023. A machine this old is past the point where the manual has new milestones to offer, and the schedule simply repeats: oil, plugs, filters and battery, checked and replaced on time, are what decide whether it reaches twenty years or fails in its fifteenth. An annual maintenance plan covers the yearly visit.
Project Facts
- Location
- Belle Mead, NJ
- Service
- Standby Generator Service
- Client since
- December 2021
- Manufacturer
- Generac Model # 5504
- Rated output
- 17 kW LP / 16 kW NG
- Fuel
- Natural Gas
- Transfer switch
- 65 amp
- Load management
- Managed Whole House
Standby generator questions from Belle Mead homeowners
Does a propane generator need permits in Belle Mead?
A permanently installed propane generator normally requires construction permits, and the propane installation has to satisfy the applicable fuel-gas and LP-gas requirements. Tank placement, capacity, piping, regulators, setbacks and fire-safety provisions all come under review.
Can a generator go under a deck?
Only if the specific installation satisfies every requirement for overhead clearance, airflow, exhaust, fire separation, carbon-monoxide safety and service access. Because the applicable guidance commonly requires substantial overhead clearance, many ordinary under-deck locations will not qualify. It is a site-specific review rather than a standard placement.
What should we do if it runs for more than a day?
Continuous running for twenty-four hours or more deserves attention. The manufacturer's continuous-use guidance covers a proper shutdown, an oil-level check, a leak inspection and maintenance based on the hours accumulated. Follow the safe shutdown procedure rather than opening or servicing a machine that is running.