Generac 14 kW Standby Generator in Farmingdale, NJ | 2,140 Sq. Ft. Covered

Standby Generator Installation and Standby Generator Service in Farmingdale, NJ
Standby Generator Installation and Standby Generator Service in Farmingdale, NJ by Green Sun Energy Services.

Farmingdale, NJ · Client since December 2012

Loren from Farmingdale, NJ has been a Green Sun Energy Services client since December of 2012. He and Marie signed in the middle of December and the generator was commissioned in May, a 14 kW Generac behind a service-rated automatic transfer switch. It covers 2,140 square feet with a refrigerator, a freezer, a dishwasher, an electric oven and the laundry. Five months was the wait that winter, when demand across New Jersey ran far ahead of what anyone could install. Farmingdale is in Monmouth County.

Project Facts

Location
Farmingdale, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
December 2012
Manufacturer
Generac Model # 6052
Rated output
14 kW LP / 13 kW NG
Fuel
Natural Gas
Home sized for
2,140 sq ft
Transfer switch
0 amp
Load management
Managed Whole House

Standby generator questions from Farmingdale homeowners

Can the existing natural-gas service in a Farmingdale home supply a generator?

Often yes, but the gas system has to be evaluated first. The review covers the generator's BTU demand, meter capacity, available pressure, regulator capacity, pipe diameter and length, and every other gas appliance in the house -- furnace, boiler, water heater, range and fireplace among them.

Will it work if nobody is home?

Yes, which is one of the main advantages over a portable generator. It has to be properly installed, fuelled, maintained, free of active shutdown alarms and left in AUTO. That matters most where an outage would otherwise stop a sump pump, the heating, refrigeration or a well pump while the house is empty.

Why is an eighteen-inch wall clearance allowed?

Because it comes from the manufacturer's tested and listed installation configuration. Applicable units are listed and labelled for installation as close as eighteen inches to a structure, subject to openings and local requirements. New Jersey adopts the National Electrical Code, which requires listed equipment to be installed in accordance with the instructions attached to that listing -- so the eighteen inches is a tested dimension, not a rule of thumb.

Scroll to Top