Generac 18 kW Standby Generator in Roosevelt, NJ | 2,619 Sq. Ft. Covered

Standby Generator Installation and Standby Generator Service in Roosevelt, NJ
Standby Generator Installation and Standby Generator Service in Roosevelt, NJ by Green Sun Energy Services.

Roosevelt, NJ · Client since November 2025

Mark from Roosevelt, NJ has been a Green Sun Energy Services client since November of 2025. He signed in mid November and the generator was commissioned in the first week of January, an 18 kW Generac on a composite pad behind a 200-amp service-rated transfer switch, with surge protection and a load management module. It carries 2,619 square feet with two refrigerators, a freezer, a dishwasher and the laundry. Roosevelt is in Monmouth County, one of the smallest boroughs we work in.

Project Facts

Location
Roosevelt, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
November 2025
Manufacturer
Generac Model # 7259
Rated output
18 kW LP / 17 kW NG
Fuel
Natural Gas
Home sized for
2,619 sq ft
Electrical service
200 amp
Transfer switch
200 amp
Load management
Managed Whole House

Supportive and professional.

— Mark2026Reviewed us onGoogle

Green Sun Energy Services replied

Thank you, Mark. Supportive is a good word for what we try to be during an install. A standby generator in Roosevelt means gas work, electrical work, permits and township inspections, and our part is to carry all of that so the homeowner only has to choose the machine. Glad the experience matched the intention.

Standby generator questions from Roosevelt homeowners

Can the existing natural-gas service in a Roosevelt home supply a generator?

Often yes, but the gas system has to be evaluated first. The review covers the generator's BTU demand, meter capacity, available pressure, regulator capacity, pipe diameter and length, and every other gas appliance in the house -- furnace, boiler, water heater, range and fireplace among them.

How quickly does it take over?

The automatic start sequence normally begins within seconds of the controller deciding that utility power has failed or fallen outside acceptable limits. There is a deliberate short delay so that a momentary flicker does not trigger a full start and transfer. Exact timing depends on the controller, the transfer switch and the configuration.

Does the residential building code apply to a generator?

It can. For applicable one- and two-family dwellings New Jersey adopts the 2024 International Residential Code, subject to state amendments. Structural and flood-related generator installations may therefore need review under the residential subcode as well as the electrical and fuel requirements.

Scroll to Top