Lise from Colts Neck, NJ has been a Green Sun Energy Services client since February of 2022. The 20 kW Generac at the house runs on natural gas behind a 90-amp transfer switch, on a plan covering annual maintenance and remote monitoring that Green Sun manages directly – set up the same month the plan started. It has been serviced every year from 2022 through 2025. Monitoring is the part that changes how a standby generator behaves: a fault reports itself rather than waiting to be discovered on the night it matters.
Project Facts
- Location
- Colts Neck, NJ
- Service
- Standby Generator Service
- Client since
- February 2022
- Manufacturer
- Generac Model # 7038-1
- Rated output
- 20 kW LP / 18 kW NG
- Fuel
- Natural Gas
- Electrical service
- 200 amp
- Transfer switch
- 90 amp
- Load management
- Managed Whole House
Standby generator questions from Colts Neck homeowners
Can an existing propane tank be reused for a new generator?
Possibly. Existing propane equipment can be reused when it is correctly sized, sited, regulated, maintained and capable of supplying the demand the generator adds. The propane supplier should verify capacity and regulator performance before the machine is commissioned rather than after.
Can the exercise time be changed?
Yes, though the procedure depends on the controller and the model, and older and newer control platforms use different setup interfaces. Remote monitoring may also offer it, depending on the generator.
Does the generator have to be bolted down?
Not every ground-level installation uses the same anchoring method. The requirement changes with the model, the pad type, wind exposure, flood requirements, elevated platforms and any local engineering requirement. The model manual and the site conditions decide it.