17 kW Standby Generator Installation in Morganville, NJ | Whole-House Standby With Load Management

Morganville, NJ · Client since October 2025

Jeannie from Morganville, NJ has been a Green Sun Energy Services client since October of 2025. The generator was commissioned in January of 2026, rated 17 kW on natural gas where the load calculation asked for 15 kW. The house has a 100-amp service, the smaller end of what a whole-house transfer switch usually sits on, so a load-management module went in alongside it: the electric range and the other large loads are held apart rather than allowed to arrive together. Our top-tier plan supports the machine, with an annual visit, an extended parts-and-labor warranty and monitoring we manage directly.

Project Facts

Location
Morganville, NJ
Services
Standby Generator Installation, Standby Generator Service
Client since
October 2025
Manufacturer
Generac Model # 7259
Rated output
18 kW LP / 17 kW NG
Fuel
Natural Gas
Home sized for
1,500 sq ft
Electrical service
100 amp
Transfer switch
100 amp
Load management
Managed Whole House

We purchased a generator last October and it was installed by Green Sun Energy Services. There were a few delays beyond their control (snow, town permits, technical problem with the actual generator), but I was so pleased with the professionalism of everyone I dealt with Glen, Karen, Jennifer, Chris and all the technicians who worked to install our generator. Early this morning I experienced our first extended loss of power due to a large tree falling in the area. After a few seconds in the dark and some supernatural sounds, our generator powered right up. Nine hours later power is still out but our generator is going strong. Definitely one of the best purchases we've made!

— Jeannie2026Reviewed us onGoogle

Green Sun Energy Services replied

Thank you, Jeannie. Snow, township permits and a fault in the machine itself is an unlucky run, and none of it is a reason to go quiet. The 17 kW standby at your home in Morganville uses load management to work inside a 100-amp service, which is a neater answer than upgrading the service. Glad the team made the wait bearable.

Standby generator questions from Morganville homeowners

Does new gas piping have to be pressure tested in Morganville?

Yes. Gas piping subject to the adopted fuel-gas code must be inspected and tested before it is accepted. New Jersey adopts the 2024 International Fuel Gas Code, which governs the inspection, the test pressure and how long the test has to hold.

What happens when the utility power comes back?

The system detects the return of acceptable utility power and transfers the house back automatically. The generator then runs through a programmed cool-down before shutting off and returning to standby. Nobody has to switch anything back by hand.

Is every generator trench eighteen inches deep?

No. Eighteen inches is a common cover requirement for certain raceway installations, but it is not a universal generator-trench rule. The code table sets different minimum cover depending on the wiring method and where it runs.

Scroll to Top