Andrew from Belford, NJ has been a Green Sun Energy Services client since August of 2025. Both jobs were signed on the same day and built six days apart, roof first.
A new roof
GAF Timberline Lifetime shingle, finished in September of 2025, taking in 280 feet of rakes, eaves and valleys. On a house this close to the bay the edges are the part that decides how a roof handles wind-driven rain, which is where the ice-and-water membrane goes.
12.9 kW of solar
Thirty Jinko 430-watt panels on IronRidge rail, finished at the end of September, with first-year production estimated at 14,192 kWh.
Six days between them
The array went onto decking with its full life ahead of it. Doing it the other way round means taking thirty panels off and putting them back, which is a job in its own right and one nobody plans for when they buy the array first.
Project Facts
- Location
- Belford, NJ
- Services
- Roofing Installation, Solar Panel Installation
- Client since
- August 2025
Solar
- Panels
- Jinko Model # JKM430N-54HL4R-B
- Panels
- 30
- System size
- 12.90 kW
- Inverter
- EnPhase IQ8PLUS-72-M-US Micro-Single
- Mounting system
- IronRidge
- Estimated first-year production
- 14,192 kWh
- Share of the home's electricity
- 100%
- Electric utility
- JCP&L
Roof
- System
- GAF Timberline Lifetime Roofing System
- Area replaced
- 2,800 sq ft
- Warranty
- 50 years
Questions from Belford homeowners
SolarAre panels designed for the wind near Belford?
Yes. The array and its mounting system have to be designed to resist the applicable wind loads, and coastal and exposed locations can carry different wind-design conditions from sheltered inland ones. It is one of the reasons the mounting system and its engineering are chosen for the site rather than by habit.
RoofingWhy do gutters overflow in heavy rain?
Usually clogging, a blocked downspout, not enough outlet capacity, insufficient pitch, or runoff concentrated from a large roof area into a short run. Standing water between storms points at pitch, sagging or a blockage instead. Water running behind the gutter is a different fault again, usually the gutter position or the roof-edge flashing.
SolarWhat happens if one panel stops working?
It depends on the architecture and on the nature of the fault. With module-level electronics a problem affecting one panel or device can often be isolated without stopping the rest of the array, and monitoring is what identifies abnormal module-level performance before anyone notices it on a bill.